[TenTec] 566 Orion II Firmware Version V3.029 ---Comments

[Mike Stricker]

Hi,

I was wondering if anyone noticed that the spectrum display reads correctly on USB but is off a bit for CW and LSB modes.  When a signal on USB is tuned in properly, the peak on the display is right at '0'.  The peak is a bit to the left of '0' for CW and LSB...about 1.6KHz for LSB.  It reads low for CW and depends on whether the mode is UCW or LCW.

The audio distortion issue seems to have been resolved.

Thanks John.

Mike, WA1SEO