[TenTec] Omni VI plus Display

[Jim Goudie]

Paul,

I have an Omni VI opt 3 that I purchased used.  I have had multiple display problems.  When I opened it up and checked out the display board, it was obvious that a previous owner had re-soldered things.  I cured some problems by fixing some bad solder joints.  And there is a small flaky problem that I haven't found yet (though the rig is currently on the shelf).

So, I'd suggest doing a good visual inspection of the board... re-solder carefully...

A second possibility, maybe to try before the other... "exercise" the connectors on the wiring that goes to that board.

73 & good luck!
Jim, AF3Z


On Aug 25, 2012, at 7:32 PM, Paul A. Ramey wrote:

> While using my radio today I lost all of the segments on the DSP1, right 
> side digit.  So now I get a read out that is 1 .225, 2 .225 instead of 
> 14.225 and 21.225.  My computer programs shows the correct freq and I am 
> TX/RX on correct freq.  Have any of you had this happen? What was the fix?
> Any one have a parts radio that wants to sell a LED display board? I am 
> also looking for the following keys that Ten Tec no longer stocks.  REV, 
> A=B and A/B
> 
> Thanks for your help
> 
> Paul, WG0G
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec