[TenTec] Model 282 filter problem

Silevitch, Michael m.silevitch at neu.edu
Sat Dec 8 16:01:33 EST 2012


Thank you Ken

Regards
    Mike K1PEV

Sent from my iPad

On Dec 8, 2012, at 12:25 PM, "Ken Brown" <ken.d.brown at hawaiiantel.net> wrote:

> There are not many parts in those filters. If you draw out the schematic by looking at the PCB traces you can reason out which parts could fail in a shorted mode, or in an open circuit mode, and cause complete loss of signal throughput. (If you do this exercise you will no doubt realize that some of the components could fail changing the filter characteristic, without making the signal throughput go away altogether.) One you have decided which components could cause total loss of signal, then consider the likely modes of failure based on what you know about the components. I would hazard to guess that them most common failure mode of crystals is open circuit, when one lead breaks off from the plate on the side of the quartz crystal. For disk ceramic capacitors ( that is all I have seen in the Ten-Tec filters) I would guess that short circuit would be the most common failure mode, but at the voltages and currents these things are subjected to in the IF of a radio, it seems unlikely they would ever fail.
> 
> You could short circuit the series crystals one at a time to see if signal comes back. Of course you will not have the proper bandpass characteristic while doing this.
> 
> The other possible cause is a failure of connections between components.This I would guess is more probable than component failure. Reflow all of the solder joints, and make sure the pins are clean. Then try again.
> 
> 73 DE N6KB
>> Does anyone have any insight into problems (and solutions) that would cause failure in a Ten Tec model 282 (or any other similar model) crystal filter? When the unit is plugged into its slot (on a Corsair) we get no response. Our next step is to test it on a network analyzer but I felt it would be worthwhile to also get inputs from people on the reflector.
>> 
>>  
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


More information about the TenTec mailing list