[TenTec] Omni VI Frequency Adjustment

[Rick W]

Well after further examination this is NOT where I need to be - hi. It looks like that is the locking crystal for all the "logic" - duh!

More serious examination is in order!

73,
Rick
VE7TK

Website: http://www.ve7tk.com



>________________________________
> From: Rick W <ve7tk at yahoo.ca>
>To: Ten-Tec Reflector <tentec at contesting.com> 
>Sent: Thursday, December 27, 2012 4:45:03 PM
>Subject: Omni VI Frequency Adjustment
> 
>
>I have recently acquired and Omni VI. The rig has seen little use in the last 10 years but it is working VERY well with a minor exception.  The rig is slightly off frequency  (about 150 Hz) - even after a significant warm-up.
>
>
>Looking at the schematic, I have found the crystal oven on the Logic Board (81606).  It looks like the crystal frequency can be tweaked with C31.  This is an early O-6 and it has the crystal oven.
>
>
>Other than C31, are there any other adjustments I should be considering? 
>
>
>Thanks.
>
>73,
>Rick
>VE7TK
>
>Website: http://www.ve7tk.com
>
>