[TenTec] Omni VI Frequency Adjustment

[Clayton Brantley]

AMEN Bob!   

Clayton N4EV




________________________________
 From: Bob McGraw - K4TAX <RMcGraw at Blomand.net>
To: Rick W <ve7tk at yahoo.ca>; Discussion of Ten-Tec Equipment <tentec at contesting.com> 
Sent: Saturday, December 29, 2012 8:37 AM
Subject: Re: [TenTec] Omni VI Frequency Adjustment
 
Start by checking and adjusting the BFO frequencies.  These must be correct 
first.  Then on to the master oscillator.

The procedure is outlined in detail in the manual.  Do follow the exact 
sequence as listed in the manual and don't skip any steps or perform them 
out of order.

73
Bob, K4TAX


----- Original Message ----- 
From: "Rick W" <ve7tk at yahoo.ca>
To: "Ten-Tec Reflector" <tentec at contesting.com>
Sent: Thursday, December 27, 2012 11:51 PM
Subject: Re: [TenTec] Omni VI Frequency Adjustment


Well after further examination this is NOT where I need to be - hi. It looks 
like that is the locking crystal for all the "logic" - duh!

More serious examination is in order!

73,
Rick
VE7TK

Website: http://www.ve7tk.com



>________________________________
> From: Rick W <ve7tk at yahoo.ca>
>To: Ten-Tec Reflector <tentec at contesting.com>
>Sent: Thursday, December 27, 2012 4:45:03 PM
>Subject: Omni VI Frequency Adjustment
>
>
>I have recently acquired and Omni VI. The rig has seen little use in the 
>last 10 years but it is working VERY well with a minor exception. The rig 
>is slightly off frequency (about 150 Hz) - even after a significant 
>warm-up.
>
>
>Looking at the schematic, I have found the crystal oven on the Logic Board 
>(81606). It looks like the crystal frequency can be tweaked with C31. This 
>is an early O-6 and it has the crystal oven.
>
>
>Other than C31, are there any other adjustments I should be considering?
>
>
>Thanks.
>
>73,
>Rick
>VE7TK
>
>Website: http://www.ve7tk.com
>
>
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec