[TenTec] OII SWR Indication Off on 10 m

[Rsoifer at aol.com]

Actually, the O II SWR sensor was never that accurate anyway, compared to a 
good external wattmeter.  The O II SWR reading is also dependent on the 
power level, i.e., it reads higher at full output than in the Tune position.  
This is not a V3 problem; it's always been there.

73 Ray W2RS


In a message dated 2/6/2012 5:53:03 PM GMT Standard Time, glhuber at msn.com 
writes:


>  
> Reply-to:tentec at contesting.com
> To:tentec at contesting.com
> Sent from the Internet 
> 
> 
> 
>