[TenTec] Omni C

[GARY HUBER]

I am fairly certain that the OMNI-C series shipped with a Molex plug 
jumpered on the accessory socket to enable the internal VFO. I had the C 
Digital model with External VFO.  The radio will NOT work without the jumper 
on the accessory socket and the VFO IN/OUT jumper OR the External VFO 
plugged into the accessory socket and the VFO IN/OUT jacks.

The External VFO when installed switches BOTH PTOs including RCV A/B, TX 
A/B, and RCV A & B (dual receive).


73 ES DX,
Gary -- AB9M

-----Original Message----- 
From: Steve Hunt
Sent: Monday, February 20, 2012 4:24 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni C

I wouldn't expect the Accessory connector to need a jumper.

>From the look of the schematics, the remote VFO system - unlike the
Corsair - leaves both PTOs running continuously; they simply switch the
PTO RF output.

Steve G3TXQ

On 20/02/2012 22:12, Paul DeWitte wrote:
> My Omni C has the accessories jack in the back, BUT it does not have a
> jumper plug in it when not using the VFO.
>
> There is a jumper in the VFO out and in. That has to be in place when not
> using the VFO.
>
> The Corsair II has a jumper in the Accessory jack when not using the VFO.
> Also the jumper for VFO out and in has to be in place when not using the
> VFO.
>
> Paul
>