[TenTec] Omni C

[Rick - DJ0IP / NJ0IP]

PIN 2 is "T"
PIN 6 is "C1"  ("common" of the spst relay)

There is no jumper required.
There is no VFO signal or connection on that jack which needs to be enabled
or disabled.

It would be nice if there were, but unfortunately the problem is elsewhere.

73
Rick, DJ0P

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of GARY HUBER
Sent: Tuesday, February 21, 2012 5:16 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni C

What are socket pins 2 and 6 ?