[TenTec] Omni C

[Michael Silevitch]

Dear Mike

Per your suggestion I looked at the voltages on the control board. Things
look OK on the input side (Pins 1-7) I see nothing on the output side
(Pins 8-14, i.e. OT POT, OT OUT, REG, etc.) I did try to loosen the board
and retighten the screws but this had no effect.


It may be that the IC is bad or another component. Any thoughts?

Regards
         Michael

****************************************


On 2/22/12 9:00 AM, "Mike Bryce" <prosolar at sssnet.com> wrote:

>mike...
>
>Now would be a good time to sit back and think about this project.
>
>If the seller said it worked, I'd ask him what "we" should do about the
>problem. 
>
>
>
>And one last idea I you haven't looked yet.  Do you have + voltage to the
>PTO? 
>
>Sent from my iPhone
>
>On Feb 22, 2012, at 8:48 AM, Michael Silevitch <msilevitch at coe.neu.edu>
>wrote:
>
>> Dear Rick
>> 
>> Thanks for this good info and advice. I may not have a chance to do much
>> more until next week since I leave or a business trip today. In any
>>event
>> I'll let you know what transpires.
>> 
>> Regards
>>         Mike K1PEV
>> 
>> 
>> 
>> On 2/22/12 2:53 AM, "Rick - DJ0IP /
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec