[TenTec] multi knob

[Ron Castro]

Rick:  I found that often the problem is caused by tiny amounts of corrosion
on the surface of the pins of the big flat cable connectors, and in the pins
of the connectors that hold the boards to each other.  Try 'massaging' all
of them and see if that helps.  If not, then the encoder itself has probably
gone bad.

             Ron Castro
                  N6IE   
         www.N6IE.com
              Member:
         REDXA   NCCC
         NCDXF   ARRL


-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Rick Dougherty NQ4I
Sent: Sunday, March 04, 2012 9:33 AM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] multi knob

Hi all..one of my Orions has a multi encoder that just won't work any
more...no matter what function you want to change, it won't...I have doen
both resets and no change...do I need a new encoder or is it battery
related?

Thanks de Rick NQ4I
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec