[TenTec] no TX after Bandpass filter kit 'upgrade' Omni D

[Scott Sheppard]

Here we go again...

After my trials and tribulations of the previous posts and getting the OMNI D to transmit as per specs, I was luck to find a fellow on teh reflector here that had an extra band pass filter board i could use that included the 30m Bandpass filter and some other warc bands...30m is my favorite band...I tried to get at least the instructions but Ten-Tec no longer has them unfortunately...

So, I replaced the complete board assembly and wired it up...rx is no problem but I have no tx output at all. Rig keys OK but nothing for output...pretty sure the problem revolves around the BP filters. Before I go into the full blown trouble shooting mode (again), does anyone happen to have a copy of the instructions for the old kit upgrade?

cheers

scott  VA3IED