[TenTec] 1340 QRP Transceiver - 12V Polarity?
Shawn Upton
kb1ckt at yahoo.com
Mon Mar 12 16:39:40 PDT 2012
One of the first things I did with my 1340 was apply power backwards. Oops. All the IC's got replaced, and on the advice of TenTec, the final too. I don't think anything else was damaged.
After that I put a series diode in. The minor power loss was less of a deal than the fear of doing that again.
Shawn
kb1ckt
------------------------------
On Mon, Mar 12, 2012 11:33 AM EDT W8KZW wrote:
>Can someone tell me the power supply polarity for this rig? I purchased a
>used one yesterday. Polarity is not indicated on the rear panel nor could I
>readily find mention of it in the manual.
>
>In my haste to fire it up I applied positive 12V to the center terminal of
>the connector and heard nothing .... dead. I have a sneaking suspicion I
>guessed wrong.
>
>If I toasted it, has anyone ever done the same and assembled a laundry list
>of what to repair / replace? Can someone tell me where supply polarity is
>referenced in the manual?
>
>I hate it when I rush.
>
>73,
>Jeff
>W8KZW
>
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
More information about the TenTec
mailing list