[TenTec] OMNI VI+ found 12m

[Joe]

Good deal. Glad you found the problem.
----- Original Message ----- 
From: "Don Rasmussen" <wb8yqj at yahoo.com>
To: <tentec at contesting.com>
Sent: Friday, March 30, 2012 2:34 PM
Subject: [TenTec] OMNI VI+ found 12m


Ten Tec had the crystal for 12m, what a blessing, but it turns out I did not 
need it, the 12m crystal is located closest to one of the board mounting 
holes. The side of the crystal closest to the hole had broken at the solder 
connection. It works FB now after resoldering it.

--- On Sun, 3/25/12, Don Rasmussen <wb8yqj at yahoo.com> wrote:

From: Don Rasmussen <wb8yqj at yahoo.com>
Subject: Re: OMNI VI+ lost 12m
To: tentec at contesting.com
Date: Sunday, March 25, 2012, 9:13 AM

Thanks Rick, I can probably cheat and set an external receiver w/probe at 
the crystal frequency, probably the next course of action.

Re: [TenTec] OMNI VI+ lost 12m
from [Rick - DJ0IP / NJ0IP] [Permanent Link][Original]

Don,

This is another case where a scope would be a real blessing.
You would see in a few seconds whether or not the oscillator were
functioning.

73
Rick, DJ0IP
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec