[TenTec] Orion II Band Data connectors/Dunestar 600 BPF

[Icatmechanic at aol.com]

Hey OLE buddy,
I don't know how the mix up occurred but here you have K7TED and I don't  
have any of the gear that you are talking about. Must be another TED
Thanks for the email anyway     K7TED
 
 
In a message dated 5/30/2012 2:11:36 P.M. Pacific Daylight Time,  
ky5rtim at gmail.com writes:

Hey  Ted;

I use a relay interface box that used to be made by Array  Solutions. It
provides
relay isolation between the O2 and the Dunestar  600 (switching +12Vdc to
the filter).
I didn't have to install jumpers  in the Dunestar 600 for negative keying.
Saying that it appears this  product is no longer available though you may
want check with  AS.

The connectors for the BD output are an AMP series. One connector  comes 
with
each new radio so I assume you have a used unit. I think there  has been
some info on this reflector for a P/N and a supplier(Mouser I  believe).

I have two Orions configured with the Dunestar 600. It allows  Multi-op
operation with no headaches. Working now on 2nd harmonic  suppression
for CW weekends.

If you can't find I have a few spares  and can part with one.

Email me direct if you can't find the  info.......

GA Tim, Ky5r

On Wed, May 30, 2012 at 11:15 AM, Ted  Bryant <W4NZ at comcast.net> wrote:

>
> Can someone please  tell me what type of connector is used for the band 
data
>  outputs?  Can't find it in the manual or on the website.
>
>  Any suggestions on connecting a Dunestar model 600 to the  Orion?
>
> Thanks!
>
> 73, Ted W4NZ
>
>  _______________________________________________
> TenTec mailing  list
> TenTec at contesting.com
>  http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec  mailing  list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec