[TenTec] Omni V filter lights don't correspond with the filters

[Clayton Brantley]

Bob:  Same thing happened here on my Omni VI+.  The logic board has 3 pins and
two on the cable.  I had put the plug on the wrong two pins.  Just moved it over one
pin and it worked right!

Clayton N4EV




________________________________
 From: Bob Towers <mm0rkt at gmx.com>
To: tentec at contesting.com 
Sent: Thursday, November 1, 2012 2:28 PM
Subject: [TenTec] Omni V filter lights don't correspond with the filters
 
Some time ago I replaced the main tuning digital encoder which was faulty.

It involved taking off the front panel and removing all the connectors at the back of it. I put it all back together and I then noticed that each filter indicator light didn't correspond with the appropriate IF filter. I had obviously put one of the connectors back wrongly. If I remember right, the connector on the front panel had 3 pins and the matching lead, 2 sockets.

The time has come to do something about it but for the life of me I can't remember which connector it was. Can anyone help?

Many thanks and 73

Bob Towers
MM0RKT

(for the reflector moderator: apologies for the previous copy of this email, sent from the wrong email address!)
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec