[TenTec] Delta II problem

[Kris Merschrod]

Dave,

A wild guess based on the only failure on my Delta since brand new -- On of 
the issues over the years, that is from the beginning of the Delta II  was 
that there were surface mounted "vxo" sections that controlled sections of 
the frequency coverage.  There was a problem with the manufacture when 
mounting those components.  My Declt II went back to TT a few times over the 
years - mostly it was at the other end of the range (10 and 15 meters).

I'd call TenTec - they will hzard a guess before you send it in.

Kris KM2KM




----- Original Message ----- 
From: "Dave" <dave at n1ix.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec at contesting.com>
Sent: Sunday, November 18, 2012 4:19 PM
Subject: [TenTec] Delta II problem


>
> The Delta II I recently purchased has a problem and I am wondering if 
> anyone
> else has experienced a similar problem.
> Output is very low on 40 meters (2 watts) and it is nonexistent (0 watts) 
> on
> 80  and 160. It is good (100 w) on 30 - 10 meters.
> I have tried the cpu master reset. I expect that the problem is on the low
> pass filter board.
>
> Dave N1IX
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec