[TenTec] An Audio Problem with Orion II and N1MM Logger

[Barry N1EU]

The short answer is I don't think you can change how N1MM controls the audio.

One option however, is for you to program keyboard function key macros
so that with a single function key press, you can potentially get the
audio set back to how you want it.

73,
Barry N1EU

On Mon, Nov 26, 2012 at 5:30 AM, Dave G3RXP <g3rxp at btinternet.com> wrote:
> Hello All.
>
> This is not a problem with my Orion 11 but it effects it, so apologies for
> the bandwidth however I hope some of you experts can help me with an
> annoying problem with N1MM.  ( I didnt get any information from the N1MM
> reflector)
>
> Its the Audio selection -  I choose to have both  Left and Right headphones
> on the main VFO and the Sub receiver on the right hand headphone only. (Im
> using SO2V) but every time I move around the N1MM windows, N1MM changes the
> Audio settings to a SO2R N1MM Default - Left main RX and the Right hand
> phone to Sub receiver.
>
> Now Im no expert at doing two things at once but it is very handy to listen
> to 10m openings while Im on 40m for example and its not off-putting if I
> only listen to a low noise level as well in one ear..
>
> So the question is can I stop these changes from N1MM in the setup or can I
> change the RS232 connections in any way.
> The result was I couldn't use the Stereo position on the phones so I had to
> set it up to Mono..........
>
> I know - I could use another contest logging program - but would it be free
> and as comprehensive?
>
> Thank You - to all those in CQWW CW for the points and the kindly way in
> which my pile ups were tolerated.
>
> 73 Dave G3RXP
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec