[TenTec] setting the display on the Omni V

[Carl Moreschi]

It's the trimmers on each band crystal.  They are difficult to change. 
If you are using my N4PY Omni V.9 chip, there's a way to calibrate each 
band from the front panel without even removing the covers.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 10/21/2012 12:26 PM, Mike Bryce wrote:
> Guys,
>
> working on a Omni V. All back together and receiving and transmitting just fine.
>
> However, the display is off, just a tad, and I can't find anyplace in the manual on how to correct the error
>
> MIDCARS at 7.258 is hear best on 7.258.11
>
> Same thing on WWV at 10.000.
>
> So, anyone knows were that correction is made?
>
>
>
> Mike, WB8VGE
> SunLight Energy Systems
> The Heathkit Shop
> http://www.theheathkitshop.com/
> J e e p
> o|||||||o
> Note: No trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>