[TenTec] Station power supply??

[Ralph]

Why??
Ralph Howes
w8bvh


----- Original Message ----- 
From: "Donnie" <cfzepp at gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Tuesday, September 04, 2012 4:14 PM
Subject: Re: [TenTec] Station power supply??


> Mike:
> I do believe that from the original Paragon and newer models such as the
> Omni V, Paragon II, Omni 6 the use of the Airpax breaker is no longer
> needed.
>
> Donnie / WA9TGT
> On Sep 4, 2012 4:04 PM, "Mike Bryce" <prosolar at sssnet.com> wrote:
>
>> Of course, when running ten tec transceivers, the use of a non factory
>> supply increases the need for an air pax fast acting circuit breaker to
>> protect the rig's final transistors.
>>
>> Mike wb8vge
>>
>> Sent from my iPhone
>>
>> On Sep 4, 2012, at 2:36 PM, Kimberly Elmore <cw_de_n5op at sbcglobal.net>
>> wrote:
>>
>> > FAR Circuits still offers their "RF Proof 30 A Power Supply" regulator
>> board.
>> > It's only the PCB -- you need to find the parts and stuff the board.
>> It's based
>> > on an article in the 1988 ARRL Handbook. I built one for my 30 A Astron
>> PS when
>> > I learned that it was extremely susceptible to RFI. I could never get
>> this
>> > regulator to act up. I made mine over 20 y ago and it still works just
>> fine.
>> > However, it (obviously) applies only to linear supplies.
>> >
>> >
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec