[TenTec] TenTec 936 PS

[Kris Merschrod]

Herman,

The 936 matched the Delta II - I bought both at the same time and that is 
the way the TenTec catalogue at that time showed it.

The power cord is a three wire type molded into the usual plug.   The output 
to the rig has the standard TenTec two wire plug that also was used up to 
the Argonaut V.  IMHO the Ga of the output wire for the Delta II should have 
been larger - it looks like #14 stranded (but I could be wrong)  I have had 
the replacement of that on my list of "to dos" for a while - use it every 
day and no problems.

It was made so that you could change the input from 120 to 220 V so there 
are jumper in there.

I do not have a schematic for the 936 or I would scan it and send it to you.

Good luck with it,

73 Kris KM2KM
----- Original Message ----- 
From: "Mike Herman" <oldwatchmaker at gmail.com>
To: <tentec at contesting.com>
Sent: Sunday, September 16, 2012 3:11 PM
Subject: [TenTec] TenTec 936 PS


> Ten tec friends-
> Bought a well used TEN TEC 936 power supply  at a local Hamfest and of
> course it had several changes...did the 936 have a 4 wire or 2 wire power
> cord??? Was the matching radio a Delta 2??? a 2 wire connector??? did it
> match the early grey Jupiters??? ( it looks close to me) I am just curious
> I looked at the TenTec web site and no 936 was listed on the expired rigs
> list of schmatics ??? 73 and thanks for any comments
> n9nf mike
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec