[TenTec] Keying loop has glitch when using Rx Ant

John K Gotwals john at gotwals.com
Sat Sep 29 14:38:22 EDT 2012


I am using an Orion with Version 3.032 firmware to drive an Acom 1000 
amplifier. I have just added a Pixel Technologies RF Pro-1B magnetic loop to 
my station and connected the loop antenna to the Rx Ant RCA jack on the back 
of the Orion. I am using a keying loop connection between the Orion and 
Acom.

I have just noticed that when the RxAnt button is activated, there is an RF 
power surge from the Orion's output when the Tune button is pressed the 
second time (to end the tuning phase). This does not happen if the receive 
antenna input is not being used (the RxAnt light is off). I have eliminated 
the problem by reverting from a keying loop connection between the Orion and 
Acom to the simpler connection consisting of connecting the Amp Key jack on 
the Orion to the Key In jack on the Acom. Of course when I revert back to 
the one wire connection between the Orion and the Acom, I have to turn off 
the keying loop in the Orion's menu.

Has anyone else had this problem?

John, N9JG 



More information about the TenTec mailing list