[TenTec] Yamaha CM500 headset and Orion II

Jim Brown k9yc at audiosystemsgroup.com
Sat Dec 14 22:14:06 EST 2013


On 12/14/2013 4:50 PM, Phil Sikes wrote:
> r use a
> commercial version? If home brew, what did you use? Secondly, I would like
> to dump the battery box that brings power to the electrets element (2xAA's)
> and make use of the +10vdc at the mike connector.

VERY simple. Make an adapter with a jack that mates with the 1/8-in plug 
and wire it to a plug that fits the Orion. Add a  5.6K resistor from 
+10V to the mic pin. Virtually no current, so you can use a very low 
wattage resistor and fit it inside the mic connector.

No PAD should be needed. The mic is fairly high output, but I've never 
seen a rig that couldn't be turned down enough.  Also, it's best not to 
crowd the mic to prevent popping and bass boost. I place the mic 
alongside my face between eye level and nose level.

73, Jim K9YC


More information about the TenTec mailing list