[TenTec] eagle

[Bob McGraw - K4TAX]

So would one surmise that removing the 2.4 KHz filter, leaving the slot 
configured for 2.4 KHz since transmit SSB mode is going to looking for a 2.4 
KHz filter, but physically installing a 6.0 KHz filter would make for even 
wider response?  Hummm, may have to try that.......on the bench of course.

73
Bob, K4TAX


----- Original Message ----- 
From: "Barry N1EU" <barry.n1eu at gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Monday, February 11, 2013 12:18 PM
Subject: Re: [TenTec] eagle


>I just took the time to read through the Eagle manual.  Much to my
> surprise, the spec section seems to indicate that ssb tx bandwidth IS
> determined by the roofing filter.  So yes, changing the roofing filter 
> from
> 2.4Khz to 2.8Khz should have a direct effect on the tx audio.
>
> 73,
> Barry N1EU
>
> On Sun, Feb 10, 2013 at 9:24 PM, Barry N1EU <barry.n1eu at gmail.com> wrote:
>
>> Is that filter is in the tx signal path of the Eagle?  The tx signal 
>> isn't
>> filtered entirely in dsp with configurable bandwidth?
>>
>> 73,
>> Barry N1EU
>>
>>
>> On Sun, Feb 10, 2013 at 4:04 PM, Rodney <w3krq at dejazzd.com> wrote:
>>
>>> I got a 2.8 filter from inrad  for my Eagle  got great audio reports.
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>