[TenTec] TenTec 544

[Al Gulseth]

I've seen the RIT/offset circuit cause this kind of issue. The offset trim pot 
may need to be readjusted. The procedure is in the manual on page 3-39 (at 
least on the copy that's posted on TT's website - the  trim pot in question 
is R16 on the 80280 Control Board.)

73 es GL, Al

On Mon February 11 2013 6:48:49 pm w5enj at juno.com wrote:
> when i key the trans.it is 500 cycles low any help would be welcome.73
> w5enj elmer johnson
> ____________________________________________________________
> Woman is 53 But Looks 25
> Mom reveals 1 simple wrinkle trick that has angered doctors...
> http://thirdpartyoffers.juno.com/TGL3141/511991b34c3fa11b25aa3st04vuc
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec