[TenTec] O II sub rcvr audio?

[Carl Moreschi]

I have also seen the connectors behind the Orion front panel cause this 
problem.  If you don't have any luck, remove the front panel and spray 
all the connectors with a good electrical cleaner.  Then connect and 
unconnect about 10 times to clean them.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 7/4/2013 5:14 PM, Ted Bryant wrote:
> What antenna do you have selected for the Sub RX, Tom?
>
> Ted W4NZ
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of
> cx7tt at 4email.net
> Sent: Thursday, July 04, 2013 4:29 PM
> To: TenTec at contesting.com
> Subject: [TenTec] O II sub rcvr audio?
>
> Hello All,
>
> Set up for split freq ops with KG4TO xmitting, listening up.  I could not
> get any audio from SubRX.  Panel set up just like Fig 4-2 of manual; Tx VFO
> B, RX VFO A, SUB RX VFOB.  Audio Menu with headphones set for Left=Main and
> Right=Both.  Nothing in right ear....no increase regardless of Sub AF audio
> gain control knob.
> I worked the dx, the old fashion way...cycling between A/B.  Also found that
> if I selected RX to VFO B the signals were nice and loud but of course the
> DX station disappeared.
>
> I tried all different combinations of the audio menu....this is the original
> sub rx board, not the RX366. O II original owner since Aug 2006, no problems
> before.
>
> Any ideas?
>
> 73
> Tom
> CX7TT
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>