[TenTec] Adapting a Kenwood mic to Ten Tec Scout

[Richards]

On 7/26/2013 5:24 PM, Stuart Rohre wrote:
   What I did for a similar case was to buy
> an inline female connector, and cross wire it with Scout mail connector.
>   That way, you keep the Scout standard Ten Tec Scout.  you can use
> short hookup wire of a couple of inches or even a four conductor
> shielded cable if you have it.



	This mirrors my own suggestion to make an
	adapter patch cable with a very short bit
	of shielded 4-conductor cable, rather than
	permanently alter the microphone, itself.



> It is good to make a drawing of the above chart connections to help you
> visualize.  Also, be aware the numbering of the connectors may be
> clockwise on one and counterclockwise on the other.



	As a headset and microphone junkie, I wire up
	microphones quite often... and I find drawing and
	charting the connections from one to the other are
  	INDISPENSABLE for making SHORT AND ACCURATE work
	of it.
	

	
Just MY take...

------------------------ K8JHR  ---------------