[TenTec] OMNI 6+ Alignment question

[Dennis R Baumgarte]

On 07/29/2013 05:50, Barry N1EU wrote:
> Don, agree with what Bob said - you need to first perform an accurate BFO
> oscillator alignment and then check the frequency of WWV.
>
> 73, Barry N1EU
>
> On Mon, Jul 29, 2013 at 2:57 AM, Don Rasmussen <wb8yqj at yahoo.com> wrote:
>
>> My frequency display is now reading 60hz high for a WWV zerobeat on USB
>> and LSB.
>>
>> Can anyone suggest if this would be the TCXO going out of tolerance or
>> possibly there is a trimmer?
>>
>> de wb8yqj/6
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
  Berry;

	Yes I do. Make sure you have the unit on for about 30 mins the do your 
calibration on the BFO; Then check it again after you cycle the radio on 
and off a few times. Rhen do a master calibration...


Dennis AE2EE