[TenTec] Need push on/off pots for Omni C

[Richard Detweiler]

Randy,  

 

Those are very hard to find,  some people ran 12V through the power switch and burned them as there weren't designe for that current.  

There were only meant to power the AC line to the power supply.

 

Best find any push/pull pot of any value then replace the resistor plate with one that works or the original if not damaged.

 

I have a surplus store here that sells the 100 ohm version in the same body style,

 

What I have done in the past is open the front of the 100 ohm one by lifting the tabs and then replaced the carbon resistor plate with the correct value.

 

If you can't use the original plate,  Make sure you find the right type of resistor plate,  there is a  audio taper and a linear taper.

 

Hope that help.

Best Wishes
Richard
K5SF

 

> Date: Tue, 11 Jun 2013 23:22:53 -0700
> From: rfulco at bellsouth.net
> To: tentec at contesting.com
> Subject: [TenTec] Need push on/off pots for Omni C
> 
> I picked up a neglected Omni C with matching supply/speaker this weekend at Hamfest. Lots of oxidation/ rust on bolts on inside. I free'd up most pots, but  the push on/off with pots --don't move in or out. Anyone got any spare's they want to part with? Randy K5SL
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec