[TenTec] audio quality on Omni VI+

[Clayton Brantley]

Tim:  Try the usual, pulling the interconnecting board to board cables.  One at a time.  Sometimes DeOxit
spray on each one (use sparingly) will clean up the connections.  I usually take a small Phillips screwdriver
and check the screws holding each board.  Over time, they will loosen.  Sometimes you might have to pull
a board out and check solder joints.  Gently tap on each board to see if there are any loose connections.
This takes time, but in the end, you most likely find the culprit and have you radio back up and running.

Good luck and 73
Clayton N4EV




________________________________
 From: wa5yom <wa5yom at swbell.net>
To: tentec at contesting.com 
Sent: Friday, May 10, 2013 7:18 PM
Subject: Re: [TenTec] audio quality on Omni VI+
 

I have an OMNI V, I am the original owner it has been kept is perfect 
condition, but recently the Transmit and receive has been 
intermittent.....per Ten-Tec.....it could cost more to fix than it is 
worth...thus I am looking for any advice on how I might proceed to fix 
it myself...or I may decide to sell it to someone that can take the time 
and expense to fix it...

Advice?

Tim
WA5YOM....

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec