[TenTec] Omni V intermittent

[Bob McGraw - K4TAX]

That's why I suggested to BYPASS the tuner in other words put the tuner in 
bypass mode.  Swapping things around may add another fault not remove a 
fault.  I've seen too many new components that were defective.  New today 
only guarantees new, not necessarily good.

73
Bob, K4TAX



----- Original Message ----- 
From: "wa5yom" <wa5yom at swbell.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, May 12, 2013 12:09 PM
Subject: Re: [TenTec] Omni V intermittent


> On 5/11/2013 7:44 PM, Mike, K9UW wrote:
>> Tim, are you using the same coax jumper from the tuner to the 930 and the 
>> Omni V?
>>
>> If not, perhaps you have a flaky connector.
>>
>> 73, de Mike, K9UW
>> Amherst, WI
>>
>>>>
>>>>
>>> Well......I have an old TS-930S and it is working fine through the same 
>>> tuner......I did however, try going direct to the Omni V.......and it 
>>> had the same problem...
>>>
>>> Tim
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>>
>>
>>
>>
> Well...I have hooked the ant...direct, no tuner, to both radio's.....
>
> The 930 works fine...the Omni V still does not work..
>
> Tim
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>