[TenTec] N4PY at Dayton

[Carl Moreschi]

Yes, my program supports up to 3 virtual comport pair hookups to allow 
up to 3 different programs to hookup all at the same time.  You would 
use NaP3 with LPPan on virtual comport pair #1, FLdigi on pair #2, and 
Winlog 32 on pair #3.

My software exports a Kenwood radio interface, so in FLdigi and Winlog 
32, they would be configured for a Kenwood radio.  And for NaP3 with 
LPPan, configure NaP3 for a K3.

All this works very well together.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 5/14/2013 1:28 PM, Randy Moore wrote:
> Question,
>
> I have a Ten-Tec Eagle that I use with HRD version 6 so I can my LP-Pan
> adapter, and all the features in HRD. I actually do not like HRD, it is
> too big and bulky and bug-ridden.
>
> I prefer to use FLdigi and Winlog 32 but then I have no LP-Pan or rig
> control. So, if I buy your rig control program will I be able to run
> Winlog 32, fldigi and the LP-Pan at the same time as your software.
>
> Thanks,
>
> Randy Moore
> AI4CO
>
>
> On 5/14/2013 7:28 AM, Carl Moreschi wrote:
>> I will be at Dayton in Booth 227.
>>
>> I offer control software for the Tentec Pegasus, Jupiter, Omni VII,
>> Orion, Orion II, Eagle, Argonaut V, Argonaut VI, RX320, RX331, RX340,
>> and RX350.
>>
>> Please stop by and say hello.
>>
>> Carl Moreschi N4PY
>> 121 Little Bell Dr.
>> Hays, NC 28635
>> www.n4py.com
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>