[TenTec] Omni VI + KC digit
Bob McGraw - K4TAX
RMcGraw at Blomand.net
Thu Nov 7 20:38:10 EST 2013
Remove the covers. Loosen the top screws to the upper left and right sides
to allow the front panel to tilt forward. Un plug all the ribbon cables,
one at a time, and re plug them. I recall that the display board and
display processor are mated with a sandwich connector. Work these apart and
re-assemble. Put it all back together and likely the problem will be
solved.
73
Bob, K4TAX
----- Original Message -----
From: "John King" <k5pgw at yahoo.com>
To: <tentec at contesting.com>
Sent: Wednesday, November 06, 2013 4:23 PM
Subject: [TenTec] Omni VI + KC digit
>I have a wonderful Omni VI+ transceiver, which I have used for many years,
>that functions beautifully EXCEPT for one digit in the digital readout that
>doesn't read. That is the kilocycle digit that doesn't read and shows
>nothing in the kilocycle range.
>
> In other words, 3.925.00 reads 3.92-.00. The readout does not display the
> kilocycles for us OLD geizers or kilohertz for the baby boomers and newer
> Ten Tec fans.
>
> Has anyone experienced intermittent digit readout such as that described
> above? If so, what did you find wrong and how did you cure the problem?
> Your input will be appreciated based upon your Ten Tec knowledge and
> experience.And YES it is plugged in. 73, John, K5PGW
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list