[TenTec] Omni C + new Ham = Oops.

[frank holladay]

If you don't, you will be reminded!
73,
Frank, K4VMO

----- Original Message ----- 
From: "Richards" <jrichards at k8jhr.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Wednesday, October 16, 2013 7:13 PM
Subject: Re: [TenTec] Omni C + new Ham = Oops.


> All good tips amounting to Axioms ... although you
> left out the most important one, i.e., one must
> remember which end is the handle.   ;-)
> 
> --------------------- K8JHR ------------------
> 
> On 10/16/2013 8:04 PM, chacuff at cableone.net wrote:
>> Well as far as soldering there are a bunch more....
>>
> ______________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec