[TenTec] Any update on a replacement for the Orion II?
Carl Moreschi
n4py3 at earthlink.net
Mon Apr 7 08:22:25 EDT 2014
You know the Omni Rig guy probably thought that because the Eagle uses
USB, it did not make a comport. If he knew it still appeared as a
comport, I bet he would add the commands.
After a bandwidth command is sent, all a program has to do is then send
a 0 bandwidth command to restore operation of the front panel bandwidth
knob.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 4/7/2014 4:40 AM, Rick - DJ0IP / NJ0IP wrote:
> For instance, Ham Radio Delux interfaces to Omni-Rig and can be used with
> any of the 75 radios on the list.
> There is lots of software using it.
>
> TEN-TEC PLEASE, whatever the Orion II replacement is, make sure it is
> supported by the Author of Omni-Rig (loan him a radio for 6 months). That
> will assure compatibility with a wide portfolio of software programs.
> (TNX)
>
> And maybe JH could write an Omni-Rig driver for the Eagle.
> I'm sure it's just a 5 minute hack if you start from the ORION2's Omni-Rig
> driver.
> To my knowledge, the only two commands needing adjustment are the bandwidth
> and mode.
> (TNX AGN)
>
> 73 - Rick, DJ0IP
> (Nr. Frankfurt am Main)
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list