[TenTec] Omni VII Digital

[Louis Ciotti]

It should not be difficult.  If using the TenTec provided cable (From
the Manual):

WHITE = pin 1, line level audio input.
YELLOW = pin 4, line level audio output.
RED = pin 5, FSK.
BLACK = pin 3, push to talk
Ground from the 46176 cable is connected to pin 2.

Have you verified the cable is correct?  It also sounds like you may
be connecting Pin 1 to the speaker output.  Not knowing what is inside
the Omni VII, I wonder if you provided it with too much voltage on
that pin at damaged the input circuit there.

On Tue, Aug 12, 2014 at 8:06 AM,  <bcarling at cfl.rr.com> wrote:
> Thank you Ed,
>
> I have tried all of those things. Still no audio on transmit wit hthe OMNI VII.
> I am glad my FT857D wasn't this difficult.
>
> 73 de AF4K, Bry
>
> On 11 Aug 2014 at 12:26, Edward Feustel wrote:
>
>> Brian,
>> I had the same problem on my Orion (565) while using FLDIGI with the
>> Ten-Tec kit to use the buffered audio input/output to/from the computer
>> soundcard:no transmit.
>>
>> It was resolved when I did three things:
>> 1. Shifted the audio input from the mike to the Accessory Input via menu
>> 2. Turned on Vox Mode via front panel button
>> 3. Adjusted the gain on the auxiliary input via the menu enough to
>> invoke the vox via the menu.
>>
>> Now it works like a champ.
>>
>> 73,
>> Ed, N5EI
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec