[TenTec] Omni VI Freq calibration
Bob McGraw - K4TAX
RMcGraw at Blomand.net
Fri Aug 29 11:13:28 EDT 2014
The OCXO is the reference for all bands. As to individual bands, there's a
crystal {10 of them total} being one for each band. The crystal oscillator
is supposed to be locked to the precision reference by a PLL. It may be
that the PLL and varactor diode is not able to pull the crystal on
frequency. All of this is on the Xtal Osc. - L.O Mixer Board.
I have noted the absolute frequency will vary from band to band by a few Hz.
And unless the BFO frequencies are not absolutely correct, you may find a
slight frequency discrepancy from mode to mode.
73
Bob, K4TAX
----- Original Message -----
From: "Brandon Brinkley" <bbrinkley at gmail.com>
To: <tentec at contesting.com>
Sent: Friday, August 29, 2014 8:48 AM
Subject: [TenTec] Omni VI Freq calibration
> My Omni VI+ is spot on. I also have an Omni VI stock no Option upgrades.
> I've noticed on 40 meters that I have to adjust 40 Hz high to be on freq.
> I've verified that with other radios. On 10.000 I have to be on 10.000.40
> to get the side tone to match up. On 20 meters it seems either spot on or
> maybe 10Hz off. I've let the radio warm up 30 mins or more, so the OCXO
> should be sufficiently warm.
>
> Any easy fix or should I look into a TCXO?
>
> 73
>
> Brandon AC4OU
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
More information about the TenTec
mailing list