[TenTec] Jupiter If output

[Carl Moreschi]

Actually I did that with my Orion.  I made a 45 mhz to 9 mhz converter 
for the sub-receiver so I could get general coverage to LPPan and 
PowerSDRIF.  The Orion sub-receiver is basically a Jupiter receiver.

But my point was for the a panadapter for the Jupiter, just run a 
panadapter radio on the same frequency and share antennas.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 12/6/2014 1:39 PM, Peter Bertini wrote:
> A 45 MHz IF is not the end of the world.... my first choice would be to use
> a higher end Dongle with 12 bit resolution (cheaper Dongles are only 8
> bit.)  They'll at least give you a usable, if not fancy, panoramic display.
>
> If you are technically inclined, it is also possible to use a simple down
> converter to bring the 45 MHz 1st IF down into a HF range that is usable
> with the L-PAN2 or other similar panoramic adapters.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>