[TenTec] Eagle 9MHz tap questions.

[Carl Moreschi]

Rick,

You can just put a Y connector between the two preselector jacks and run 
the third leg to a panadapter radio such as the Softrock Ensemble II. 
This works great.  My software will keep the softrock and Eagle on the 
same frequency.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 12/23/2014 1:18 AM, Drago wrote:
>
>
> -----Izvorna poruka----- From: Rick - DJ0IP / NJ0IP Sent: Tuesday,
> December 23, 2014 5:32 AM To: 'Discussion of Ten-Tec Equipment' Subject:
> Re: [TenTec] Eagle 9MHz tap questions.
> I was wanting to add a pan-adapter.
> I may have to replace a board in order to do that.
> My unit does not have the TMP jack with the 9 MHz out.
>
> Also I have to find a way to run the signal out the back.
> I already have two spare RCA Phono jacks in use for the pre-selector.
>
> 73 - Rick, DJ0IP
> (Nr. Frankfurt am Main)
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of Richards
> Sent: Tuesday, December 23, 2014 2:49 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Eagle 9MHz tap questions.
>
> Are you going to add a panadapter ?
>
> ================== K8JHR ==================
>
>
> On 12/22/2014 2:46 PM, Rick - DJ0IP / NJ0IP wrote:
>> Is it just a tap, like perhaps a Y-connection, or does it also have a
> buffer stage?
>> Unfortunately my Eagle fell out of the nest before that feature was added
> to the radio.
>> ____________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>