[TenTec] Ten Tec Centaur 411 10m Mod Needed
Kris Merschrod
Kris at merschrod.net
Fri Feb 14 07:13:45 EST 2014
Focus guys focus.
The manual , p 5-1, tells it all. When I did the modification, T-T was most
helpful and sent the schematic and the parts! (no charge - inductors and
caps and all). This was a few years ago and T-T had the few parts that were
needed. I But with T-T instructions and specs, this mod is easier than
building a Pi net for a QRP rig b/c you do not have to build your own board!
The toriods can be bought and wound, the caps are stock.
On my jumper approach - It was into a dummy load just to see if I was into
the right place - no pink slip and no, I did not go into the 10-10 annual
competition!
Kris KM2KM
----- Original Message -----
From: "Jim Brown" <k9yc at audiosystemsgroup.com>
To: <tentec at contesting.com>
Sent: Thursday, February 13, 2014 11:29 PM
Subject: Re: [TenTec] Ten Tec Centaur 411 10m Mod Needed
> On 2/13/2014 10:39 AM, w8au at sssnet.com wrote:
>> You have to
>> fabricate your own board, which goes in place of the 15 meter output
>> filter.
>
> My comments re: harmonic suppression were based on this statement. If W8AU
> is mistaken and the the filter in question is an INPUT network, my
> comments do not apply. :)
>
> 73, Jim K9YC
>
> 7
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
More information about the TenTec
mailing list