[TenTec] Corsair II UV EPROM failure

[Mike Bryce]

I was going to say something about doing that on the forum bit though for sure someone  would had mentioned it. 

Mike wb8vge 

Sent from my iPhone

> On Feb 19, 2014, at 9:29 PM, "A R" <raf_3 at msn.com> wrote:
> 
> Mike,
> 
> Thanks! Pulled the P22 plug (schematically labeled "KEY/GND", and the processor keyer output is disabled, AND I still have straight key/bug CW capability. I can sure live with that.
> 
> 73!
> Allen----W7GIF
>  ----- Original Message ----- 
>  From: Mike Bryce<mailto:prosolar at sssnet.com> 
>  To: Discussion of Ten-Tec Equipment<mailto:tentec at contesting.com> 
>  Sent: Wednesday, February 19, 2014 4:02 PM
>  Subject: Re: [TenTec] Corsair II UV EPROM failure
> 
> 
>  Iam surprised no one mentioned this before 
> 
>  Unplug the two wire plug ( that is the output from the microprocessor near q3) on the 81246 logic board. 
> 
>  Problem solved! 
>  Mike wb8vge
> 
>  Sent from my iPhone
> 
>> On Feb 19, 2014, at 5:31 PM, Steve Berg <wa9jml at frontier.com<mailto:wa9jml at frontier.com>> wrote:
>> 
>> Allen, you do not have to use the internal keyer in the Corsair II. If you do, there is a jumper with two RCA phone plugs on it that goes from the keyer out connector to the key connector.  I unplug that many times to hook up my bug or straight key.  I just plug them into the key jack once the jumper is removed.
>  _______________________________________________
>  TenTec mailing list
>  TenTec at contesting.com<mailto:TenTec at contesting.com>
>  http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>