[TenTec] Does this happen to you on transmit...OMNI V ??

[Doug Reid]

There are so many possible causes for this problem.  In avionics installations, we try to keep all transmission lines from various radios away from each other as much as possible. Maybe a coax line inside your rig is has a broken shield connection, or is coupling rf to another circuit ? 

Doug Reid
WD4LNW



-----Original Message-----
From: Scott Shepard <scottsheppard at videotron.ca>
To: tentec <tentec at contesting.com>
Sent: Mon, Feb 24, 2014 5:30 pm
Subject: [TenTec] Does this happen to you on transmit...OMNI V ??


I am going  thru a variety of projects presently and am now at the omni V ...it 
eems on most bands above 80 m if I increase power to past 3/4 point the display 
lanks out and it gets stuck in tx mode...as though swamped with RF...I have the 
ew chip 9.v2 ...I have to turn the rig off in order to reset the controls...any 
deas or similar experience?
Kind regards
Scott VA3IED
Sent from my iPad
______________________________________________
enTec mailing list
enTec at contesting.com
ttp://lists.contesting.com/mailman/listinfo/tentec