[TenTec] OMNI VI TX Audio Bd Connector 46 Test Lead

[Barry N1EU]

I've always just used clip leads.

Barry N1EU

On Sun, Jan 12, 2014 at 8:58 PM, Reed Christiansen <reed at wi9p.com> wrote:
> I am wanting to calibrate the BFO oscillators per page 4-43 of the manual.  I cannot get my frequency counter probe into the small RG-174 jack at Connector 46 of the TX audio board.  So, I suppose I need to rig up a test lead that will plug in at Connector 46.
>
> Does anyone have a supplier/part number for the male RG-174 plug that attaches at Connector 46?  Or, even better yet, for about a one foot run of coax with that plug on one end and a BNC connector on the other end?
>
> Thanks for any advice you might be able to provide.  73.
>
> --
> Reed L. Christiansen, WI9P
> Email: reed at wi9p.com
> http://www.wi9p.com
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec