[TenTec] 422 Centurion blowing fuses...

[Bob McGraw - K4TAX]

The filaments, bias, control voltage and HV comes up when the power switch 
is ON.  The Standby-Operate switch controls the QSK board and standby bias 
control.

73
Bob, K4TAX


----- Original Message ----- 
From: "Clayton Brantley" <clayton_n4ev at yahoo.com>
To: "Brian Carling AF4K" <bcarling at cfl.rr.com>; "Discussion of Ten-Tec 
Equipment" <tentec at contesting.com>
Sent: Thursday, January 30, 2014 5:08 PM
Subject: Re: [TenTec] 422 Centurion blowing fuses...


I'd check the HV power supply diodes. Bet one or more is shorted.

Clayton N4EV





On Thursday, January 30, 2014 5:41 PM, Bry Carling <bcarling at cfl.rr.com> 
wrote:

Thanks Rod and PC. I already tried disconnecting the plate transformer 
secondary and it still
blew fuses. I think I have a bad transformer. I will check it further but 
looks like a serious
expense to buy a replacement Hypersil transformer from Tentec. I will check 
everythkngelse
first but this doesn't look good.

73 Bry AF4K

On 30 Jan 2014 at 16:48, PC Anderson wrote:

> I would pull the plate caps off first and see if ur still blowing
> fuses.Andy
>
> Talk is cheap, Action counts!
>
> >
> > one of the tubes may be shorted take them out and check the pins
> for shorts
> > 73 Rod
> >
> >
> >
> > I have a Tentec 422 Centurion that is blowing the main 20 Amp
> fuses...
> >
> > Looking for insights to this amp failure. It started
> spontaneously.
> > I can turn on the main power OK and the filaments light up on
> the
> > 3-500Zs. The 12 volt power supply is OK because the pilot lights
> come on.
> > However when I flip the standby - operate switch to the Operate
> positionm
> > the fuse or fuses will blow. I replaced them with good 250V 20A
> cuses.
> >
> > I checked the plate transformer windings and everything seems
> normal for
> > all three windings. Nothing is shorted. The safety ground for the
> cover-open
> > condition is not
> > across the HV plate supply. I checked that nothing else is
> shorting out the
> > plate supply
> > either.
> >
> > Does anyone have any idea what might be going on here?
> >
> > Many thanks - Brian Carling, AF4K
> >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec

> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec