[TenTec] Source for TITAN 425 plate choke?

[Rick - DJ0IP / NJ0IP]

I replaced the plate choke in my QRO Technologies HF-1000 amp with the MFJ
plate choke.
That was about 10 years ago.  As I recall, it was just under $30, and worked
great.

73 - Rick, DJ0IP
(Nr. Frankfurt am Main)


-----Original Message-----
From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of Jerry
Haigwood
Sent: Friday, July 18, 2014 12:11 AM
To: 'Dave Bowker'; 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] Source for TITAN 425 plate choke?

Hi All,
    Has anyone mentioned that MFJ sells the Plate Choke they use on their
amps?  The plate choke uses a ceramic form 1 inch diameter and 5.5 inch
long.  It has three connected coils to break up resonances and appears to be
very well made.  I have one but I don't remember what the cost was.  I think
it was about $30.

Jerry W5JH
"building something without experimenting is just solder practice"

-----Original Message-----
From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of Dave Bowker
via TenTec
Sent: Wednesday, July 16, 2014 2:11 PM
To: tentec at contesting.com
Subject: [TenTec] Source for TITAN 425 plate choke?

The first thing I recommend is determine why the existing choke failed.
Unless you correct the cause, the effect will be the same with a replacement
choke, no matter who the mfr/supplier is.


73, Dave, K1FK
Fort Kent, ME
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec