[TenTec] Omni VI Help

[DAVID]

Hi Barry, DC connector looks to be factory wired with heat-shrink tubing so looks OK. 
I did check the voltages at that connector and they looked fine, but thanks for the thought. 

Dave K9UX 

----- Original Message -----

From: "Barry N1EU" <barry.n1eu at gmail.com> 
To: "List, Ten" <tentec at contesting.com> 
Sent: Monday, June 16, 2014 8:09:28 AM 
Subject: Re: [TenTec] Omni VI Help 

Are you sure the dc connector (white 4-pin molex) on the power cable is 
properly wired? 

Barry N1EU 


On Mon, Jun 16, 2014 at 11:02 AM, DAVID <k9ux at comcast.net> wrote: 

> Hi everyone. I need some advice on an Omni VI I picked up at an estate 
> sale. It's a nice looking rig, loaded with filters, but 
> it will not power up. It is shorting the DC voltage to ground it appears. 
> Took it to a friend's house and hooked it to an Astron 
> 30 amp supply and the voltage dropped to zero!! Darn!! 
> So can anybody give me some advice as to what to look for or should I just 
> bite the bullet and send it to Ten Tec?? 
> 
> Thanks in advance, Dave K9UX 
> _______________________________________________ 
> TenTec mailing list 
> TenTec at contesting.com 
> http://lists.contesting.com/mailman/listinfo/tentec 
> 
_______________________________________________ 
TenTec mailing list 
TenTec at contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec