[TenTec] Orion 565 tuning encoder

[Barry N1EU]

I measure 4.63V on both tuning encoders.  And both encoders work on the A
cable, so it doesn't seem like that would explain it.  But I'll poke around
the A9 board.  I replaced all the A9 capacitors a few months ago.

Thanks & 73,
Barry N1EU


On Sat, Jun 21, 2014 at 5:23 PM, shristov <shristov at ptt.rs> wrote:

>
> Barry N1EU <barry.n1eu at gmail.com> wrote:
>
> > Thanks Sinisa.  vfoB would not tune at all.
>
> I had the same problem.  VFO B encoder had a supply voltage of only 4.66 V.
> After tightening 4 fixing screws on the A9 board, the voltage at encoder
> rose to 4.77 V
> and it started workig.
>
> 73,
>
> Sinisa
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>