[TenTec] RX320 & Pegasus rig control

[Clayton Brantley via TenTec]

Darrel:  Any program that will control a Jupiter will work the Pegasus.  The Jupiter is a Pegasus with a
front panel.   Don't know about the '320.  Might give N4PY a try since he writes all the good programs
for the TenTec and outhers.

Clayton N4EV


On Friday, May 16, 2014 2:19 PM, Darrel <74010.2230 at compuserve.com> wrote:
 


   I have recently been using my RX320 and Pegasus to monitor the 
NCDXF beacons, using the program Faros.  (See 
http://www.dxatlas.com/faros/.)  This a great program for monitoring 
the beacons, and can tune the receiver to different bands 
automatically. The list of rigs specifically supported (see 
http://www.dxatlas.com/OmniRig/) includes the
Ten-Tec Paragon II, Ten-Tec Orion, Ten-Tec Omni VI+, Ten-Tec Omni VII 
and TenTec RX-350, as well as many Kenwood, Yaesu, Icom and other 
rigs.  However, I have not succeeded in making the program control my 
TenTec RX320 or Pegasus.

  Does anyone know if the RX320 or Pegasus computer control protocol 
is compatible with any of the other TenTec rigs listed above?

                  Thanks,
                     73
                       Darrel, aa7fv.

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec