[TenTec] Eagle problem?

Jim Brown k9yc at audiosystemsgroup.com
Sat May 17 00:43:15 EDT 2014


I stopped by the Ten Tec booth today, and looked at both an Eagle and an 
Omni VII that were on display. I did not open them up, but it certainly 
appeared  that most of the connectors appear to be mounted to the 
circuit board and in their enclosure such that the connector shells to 
not contact the chassis.

I then had a brief conversation with John Henry, pointing to him what 
looked very much like multiple Pin One Problems in these two radios, and 
that they were a likely cause of the RFI complaints currently being 
discussed on this reflector. He seemed to be paying attention. Because 
he was quite busy in the booth, I purposely kept our discussion brief.

73, Jim K9YC




More information about the TenTec mailing list