[TenTec] Relationship between the Pegasus and Jupiter -

[Ron Notarius W3WN]

The Jupiter was developed as the "Pegasus FP" -- FP for Front Panel.

A Jupiter IS a Pegasus, but a Pegasus is NOT a Jupiter -- the Jupiter has an
additional command set when not emulating the Pegasus.

The Pegasus/Jupiter has an interesting history, you can find out a lot with
a little bit of searching the Internet.  Especially when you compare it to
the Kachina 505 DSP rig, which sold new (at the time) for circa $2000 -- the
Pegasus outperformed it (a point I know some will argue) for about half the
cost, IIRC.

73, ron w3wn

-----Original Message-----
From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of Richards
Sent: Tuesday, November 25, 2014 4:16 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Relationship between the Pegasus and Jupiter -

TT  Equipment Question:

What is the technical relationship between the  Pegasus and Jupiter - do 
they use different command sets?  Are they the same rig, but one has a 
set of front panel controls?  Is there a previously written explanation 
of this I can read?

Thanks.
----------------------K8JHR -------------------------------
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com