[TenTec] Orion II Main Rx

[Bob McGraw - K4TAX]

Seems would be time for internal connector cleaning project.  It does take 
time to remove one at a time, use a good contact cleaner, Deoxit etc, small 
amount applied to a Q Tip, wipe the male pins and then plug in the 
connector.  Move on to the next one.  The ones attached to PC boards on the 
front are suspect.

If all else fails, call Paul at Tentec service for a RA number.

73
Bob, K4TAX



----- Original Message ----- 
From: "David W LeJeune, Sr" <lejeuned at centurytel.net>
To: <TenTec at contesting.com>
Sent: Friday, September 12, 2014 8:11 PM
Subject: [TenTec] Orion II Main Rx


> Just fired up my Orion II for the first time in 2 years.  It was working
> perfectly when I last used it.  Now I find that the main Rx isn't working.
> Sub Rx works fine.  Tx works fine.  Both VFO's work fine.  Any ideas 
> before
> I bundle it up and send it back to TenTec?
>
>
>
> Dave WN5V
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>